Art Blog

«
»

Forging ahead

December 9, 2010 | Filed in:

Last week, which did not get a blog post, I started creating the external surface of the chicken. Starting with a large rectangle of relatively thin plate steel, I cut out rounded shapes with an Oxyacetalyne cutting torch. Then I heated up small areas of those pieces with a rosebud torch, and banged on them with a hammer to shape them. This proved to be slow and frustrating. The area that the rosebud could heat up was just too small.

This week I tried using a small forge instead (pictured first above). This limits the size of the steel pieces I can use, but that proved to be a worthy sacrifice, because the forge heats up pieces fully and I could shape them more easily. The chicken now has a few additional pieces attached, and four more have been forged and will be attached next week. I also took some time to strengthen the welds at the heel and hip joints; the upper part of the chicken is getting heavy and I don’t want it to collapse. At this moment, the chicken can stand on its own! The balance will go off and on again over time, but hopefully it will end up stable.

 

Leave a comment